The output (snipped to relevant line): reshape = % () finish=min speed=/sec It also looked like my services were running slower than normal / possible. I followed their instructions but 2 days after installing the device, I noticed in the GUI that I was at less than 20% finished checking parity. I wanted to expand my Synology SHR raid by adding 1 new drive. Inspecting a setup - do this first if you're new to the hardware you're working on!.
If you're new to linux, or this is a new piece of hardware / a new synology device, jump down to the section called "Inspecting a setup" Contents I had to customize the commands after exploring my particular system's setup. Warning: The exact commands may not match for your particular linux OS / Synology(NAS) device.
0 kommentar(er)
